Britax SICT Easy Adjust 7200/A/2010 Series Instructions For Use Manual page 35

INSTALLING INTO VEHICLE FORWARD-FACING
(UPRIGHT OR RECLINED)
M. Fit the attachment clip to the anchor fitting as shown.
Make sure to remove as many twists as possible from the
upper anchorage strap. Refer to the car owners handbook
for the location of the child restraint anchor fitting.
Always attach the hook and remove slack
N. Tighten adjustable upper anchorage strap by pulling
adjustment strap to remove slack as shown below, but
do not over-tighten causing the restraint base to lift off
the vehicle seat.
O. Roll up excess strap tightly so the webbing is thick
enough to be held in the storage band and is away from
child's reach.
CAUTION:
Always roll up the excess strap otherwise it may hang
outside the car door or could strangle a child.
IMPORTANT:
Check that the seatbelt is not twisted and the diagonal
belt is only clamped by the lock-off which is located
on the opposite side from the car seat buckle.
HOW TO SETUP
Attachment Clip
Car's Anchor Fitting
M
Press
Pull Adjustment Strap
to remove slack
N
O
Storage
Band
35