Britax SICT Easy Adjust 7200/A/2010 Series Instructions For Use Manual page 54

INSTALLATION OF CAR ANCHOR FITTING
IF THE CAR IS FITTED WITH CHILD
RESTRAINT ANCHORAGE POINT
Locate the anchorage point behind the rear seating position.
(consult the car owners handbook for the location of the
anchorage point). The anchorage point should be directly
behind and central to the restraint. Remove thread plug from
the parcel shelf/floor/roof, etc. and install anchor bolt and
fitting as shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ANCHOR BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 Nm (14.75 ft.lb.)
Note: Minimum of five full turns of anchor bolt is required
before tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT ANCHORAGE POINTS
For Sedans only - Drill 9mm diameter hole in the parcel shelf
on the centre line of the seating position as shown in Fig 3.
Before drilling the hole, check the underside for accessibility.
Install the anchor bolt as shown in Fig 2.
For vehicles other than Sedans - In Australia, consult your
nearest child restraint fitting station or traffic authority for
vehicle inspection to find the best, correct position for
the placement of the anchorage point, and for the correct
attachment bolt length and use of spacers. In New Zealand,
consult the agent for the vehicle.
Note to Queensland purchasers: The installation of
anchorage points must be approved by authorised officers
appointed by Queensland Transport. Authorised officers can
be sourced from all Queensland Transport Customer Service
and Queensland Ambulance Service Centres.
54
UPPER ANCHORAGE FITTING
Fig.1.
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Front of Vehicle
UPPER ANCHORAGE FITTINGS
FOR SEDANS ONLY
Fig.2.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Reinforcing
washer (cone
downwards)
Lock washer
Secure nut