Britax SICT Easy Adjust 7200/A/2010 Series Instructions For Use Manual page 17

H. Fit the attachment clip to the car's anchor
fitting as shown. Make sure to remove as
many twists as possible from the upper
anchorage strap. Refer to the car owner's
handbook for the location of the child
restraint anchor fitting.
I. Tighten the adjustable upper anchorage strap
by pulling adjustment strap (C) to remove
slack, but do not over-tighten causing the
restraint base to lift off the vehicle seat. This
will usually be done once the baby has been
harnessed into the seat. Roll up excess strap
tightly so the webbing is thick enough to be
held in the storage band.
The strap will usually fit around the outside of
the Side Impact Cushion. Do not over tighten
the upper anchorage strap, just remove the
slack from the upper anchorage strap.
HOW TO SETUP
Attachment Clip
H
Fully press Adjuster Button
(A) while pulling Upper
Anchorage Strap (B) to
A
lengthen.
Storage
Band
I
Roll up excess strap
tightly so the webbing is
thick enough to be held
in the storage band.
Car's Anchor Fitting
B
C
Pull Adjustment Strap
to remove slack
17