Exhaust Gas Recirculation (Egr) Valve - International VT 365 Service Manual

MANIFOLDS AND EXHAUST GAS RECIRCULATION (EGR)
94

Exhaust Gas Recirculation (EGR) Valve

Figure 128 EGR valve assembly
1. Large O-ring
2. Valve group O-rings (2)
3. Common pintle shaft
1. Install a large O-ring on the EGR valve.
2. Lubricate two new valve group O-rings with
a solution of dish washing soap and water
(approximately 50/50 mix) and install O-rings on
EGR valve.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Figure 129 Seat EGR valve
3. When installing the EGR valve into the intake
Figure 130 Insatallation of EGR valve
1.
2.
3.
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
manifold, make sure the valve is completely
seated by hand before installing bolts.
NOTE: Failing to completely seat the EGR valve
into the intake manifold, before inserting the
mounting bolts, may cause damage to the EGR
valve.
M6 x 35 bolt
EGR valve
8-pin electrical connector