International VT 365 Service Manual page 66

ELECTRONICALLY CONTROLLED VARIABLE GEOMETRY
62
9. Disconnect oil supply tube from engine by
removing the M8 x 20 flange head bolt.
10. Remove oil supply tube from oil cooler cover
assembly.
Figure 54 Exhaust adapter V-clamp for VGT
11. Remove exhaust adapter V-clamp.
12. Cover all openings to the VGT when piping is
removed, to keep out foreign material.
Figure 55 Center mounting bolt and spacer for
VGT
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
TURBOCHARGER (VGT)
13. Remove M8 x 30 flange head bolt and spacer
Figure 56 Rear mounting bolt for VGT
14. Remove M8 x 30 flange head bolt securing the
Figure 57 Front mounting bolt and spacer for
VGT
15. Remove one M8 x 30 flange head bolt and spacer
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
securing the VGT to the center of mounting
bracket.
VGT to the rear of mounting bracket.
securing the VGT to the front of mounting bracket.