International VT 365 Service Manual page 83

MANIFOLDS AND EXHAUST GAS RECIRCULATION (EGR)
1. Disconnect 8-pin electrical connector from EGR
valve.
Figure 90 EGR valve retaining bolts
Figure 91 EGR valve retaining bolts
2. Remove two M6 x 35 EGR valve retaining bolts.
3. Turn the EGR valve counterclockwise.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Figure 92
1.
2.
3.
4. Install the EGR valve puller (Table 9).
Figure 93 EGR valve puller installed
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
EGR Valve Puller
Screw
J arm with tab
Puller legs
79