International VT 365 Service Manual page 67

ELECTRONICALLY CONTROLLED VARIABLE GEOMETRY
NOTE: If removing the VGT only, cap off oil drain line
to keep out foreign material.
16. Lift the VGT assembly up and off the engine.
Make sure all openings in the VGT assembly are
capped.
NOTE: Use Compressor Inlet Cap and Exhaust Outlet
Cap. (Table 6). If plastic caps are not available, cover
openings with tape.
Figure 58 Oil drain tube for VGT
Figure 59 Removal of oil drain tube for VGT
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
TURBOCHARGER (VGT)
17. Pull oil drain tube out of high-pressure oil pump
18. Put a cap over opening in the high-pressure oil
19. Remove two O-rings on the oil drain tube and
Figure 60 VGT bracket bolts
Figure 61 Removal of VGT bracket bolts
20. Remove four M8 x 20 VGT bracket bolts.
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
cover.
pump cover to keep out foreign material.
discard.
63