MANIFOLDS AND EXHAUST GAS RECIRCULATION (EGR)
Exhaust Gas Recirculation (EGR) Cooler
Figure 101 EGR cooler retaining bolts
1.
Bolt (M6 x 20) stud (2)
2.
Bolt (M6 x 16)
1. Put intake manifold on workbench.
2. Remove two M6 x 20 stud bolts and one M8 x
16 bolt securing the EGR cooler to the intake
manifold.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Figure 102 EGR cooler assembly
1.
2.
3. Remove cooler assembly and discard gasket.
4. Remove O-ring.
5. Remove and save boss grommets.
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
EGR cooler to intake manifold gasket
EGR cooler O-ring
83