Intake Manifold And Egr Cooler - International VT 365 Service Manual

MANIFOLDS AND EXHAUST GAS RECIRCULATION (EGR)
Figure 111 EGR cooler retaining bolts
5. Tighten all three fasteners to the standard torque
(Standard Torques, page 375).

Intake Manifold and EGR Cooler

Figure 112 Front module seal
1. Install a new front module seal between the intake
manifold and front cover module.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Figure 113
centering tab
2. Position a new intake manifold gasket on each
3. Remove protective magnetic covers (Table 9)
Figure 114 Intake manifold and EGR cooler
assembly
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
Intake manifold gasket with
side of intake manifold and run two bolts through
each side to hold gaskets. Make sure centering
tabs are facing up in the manifold, while positioned
inboard toward the engine valley.
from cylinder head intake ports.
87