Electronically Controlled Variable Geometry Turbocharger (Vgt) - International VT 365 Service Manual

ELECTRONICALLY CONTROLLED VARIABLE GEOMETRY
Figure 51 Breather tube and pitot tube
1. Air inlet duct
2. Breather hose
3. Pitot tube
4. Remove air inlet duct breather hose by turning
breather hose and pitot tube enough to align hold
clips with opening, to remove from the crankcase
breather cover.
5. Put caps in the opening of the breather cover vent
hole, to keep out foreign material.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
TURBOCHARGER (VGT)
Figure 52 Oil supply tube to VGT
1.
2.
6. Remove two M8 x 20 bolts from the oil supply tube
7. Remove oil supply tube gasket and discard.
8. Put a cap over oil supply inlet to the VGT, to keep
Figure 53 Oil supply tube for VGT to oil cooler
cover assembly
1.
2.
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
Oil supply tube
Mounting bolt (2)
mounted on top of the VGT and swing oil supply
tube out of the way.
out foreign material.
Oil supply tube
Mounting bolt
61