Removal; Vgt Control Valve Removal (If Required) - International VT 365 Service Manual

ELECTRONICALLY CONTROLLED VARIABLE GEOMETRY

Removal

WARNING: To prevent personal injury or
death, read all safety instructions in the "Safety
Information" section of this manual.
WARNING: To prevent personal injury or
death, shift transmission to park or neutral, set
parking brake, and block wheels before doing
diagnostic or service procedures.
WARNING: To prevent personal injury or
death, make sure the engine has cooled before
removing components.
WARNING: To prevent personal injury or
possible death, disconnect the main battery
negative terminal before
connecting electrical components.
WARNING: To prevent personal injury or
death, do not let engine fluids stay on your skin.
Clean skin and nails, using a hand cleaner, and
wash with soap and water.
clothing and rags contaminated with engine
fluids.
NOTE: Engine fluids (oil, fuel and coolant) are a threat
to the environment. Recycle or dispose of engine
fluids according to local regulations. Never put engine
fluids in the trash, on the ground, in sewers or bodies
of water.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
TURBOCHARGER (VGT)
Figure 46
disconnecting or
1. Disconnect
Wash or discard

VGT Control Valve Removal (If required)

NOTE: The VGT control valve should only be
removed
troubleshooting VGT problems.
Figure 47 Retaining bolt for VGT control valve
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
Disconnection of VGT control valve
1. VGT control valve connection
2. VGT control valve
3. VGT control valve connector
4. VGT control valve bracket
the engine
connector from the VGT control valve.
for cleaning
1. VGT control valve bracket
2. Retaining bolt
59
harness electrical
and inspection, when