International VT 365 Service Manual page 75

ELECTRONICALLY CONTROLLED VARIABLE GEOMETRY
3. Install control valve bracket and retaining bolt and
tighten bolt to standard torque (Standard Torques,
page 375).
Figure 79 VGT control valve
1. VGT control valve connection
2. VGT control valve
3. VGT control valve connector
4. VGT control valve bracket
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
TURBOCHARGER (VGT)
death, disconnect the main battery negative
terminal before disconnecting or connecting
electrical components.
1. Connect the VGT control valve to the electrical
2. Reinstall all safety guards, shields, and covers.
3. Make sure all tools, cleanliness covers, loose
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
WARNING: To prevent personal injury or
harness.
parts, and service equipment are removed from
the engine work area.
71