Installation; Variable Geometry Turbocharger (Vgt) And Components - International VT 365 Service Manual

ELECTRONICALLY CONTROLLED VARIABLE GEOMETRY

Installation

Variable Geometry Turbocharger (VGT) and
Components
Figure 65 VGT bracket
1. Place VGT bracket in engine valley by putting right
side of bracket under EGR cooler coolant inlet
tube. Then lower left side over bolt holes.
Figure 66 VGT bracket bolts
2. Install four M8 x 20 mounting bolts to secure
VGT bracket to crankcase. Tighten bolts to the
standard torque (Standard Torques, page 375).
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
TURBOCHARGER (VGT)
Figure 67
tube for VGT
3. Install two new oil drain tube O-rings and lubricate
4. Remove cap and install drain tube in the
NOTE: If not immediately installing the VGT, install a
cover over the oil drain tube.
Figure 68 VGT alignment dowels and bosses
1.
2.
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
Lubrication for O-rings on oil drain
both O-rings with clean engine oil.
high-pressure oil pump cover.
Alignment dowel
Alignment boss
67