Intake Manifold And Egr Cooler; Fuel System - International VT 365 Service Manual

MANIFOLDS AND EXHAUST GAS RECIRCULATION (EGR)
80
5. Slip the pin of each J-arm under and in the bolt
hole of the EGR mounting flange and hook the top
end in the puller beam.
6. Position the puller legs over the EGR bolt holes in
the intake manifold.
Figure 94 EGR valve removed
7. Turn threaded shaft clockwise to remove EGR
valve.
CAUTION: To prevent engine damage, after removing
the EGR valve, vacuum loose carbon deposits and
debris from inside the intake manifold.
8. Remove and discard three O-rings.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.

Intake Manifold and EGR Cooler

NOTE: Before removing intake manifold, remove the
following components:
•
•
See "Fuel System" and "Electronically Controlled
VGT" sections for removal procedures.
death, wear safety glasses with side shields to
protect eyes. Limit compressed air pressure to
207 kPa (30 psi).
CAUTION: To prevent engine damage, blow out or
vacuum dirt and debris under the intake manifold. This
prevents dirt and debris from entering intake ports
when the manifold is removed.
Figure 95 Intake heat shield mounting nuts
(right side)
1. Remove two M6 intake heat shield nuts on the
2. Remove heat shield.
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
Fuel Filter Housing and Lines
VGT
WARNING: To prevent personal injury or
right side of the intake manifold.