MANIFOLDS AND EXHAUST GAS RECIRCULATION (EGR)
Removal
Exhaust Manifolds and Tubing
Left Exhaust Manifold and Tubing
WARNING: To prevent personal injury or
death, read all safety instructions in the "Safety
Information" section of this manual.
WARNING: To prevent personal injury or
death, shift transmission to park or neutral, set
parking brake, and block wheels before doing
diagnostic or service procedures.
WARNING: To prevent personal injury or
death, make sure that the engine has cooled
before removing components.
NOTE: Engine fluids (oil, fuel and coolant) are a threat
to the environment. Recycle or dispose of engine
fluids according to local regulations. Never put engine
fluids in the trash, pour fluids on the ground, in sewers
or bodies of water.
Figure 83 Manifold mounting bolts for shielded
tube exhaust assembly
1. Remove two M8 x 60 bolts securing the shielded
tube exhaust assembly on left exhaust manifold.
NOTE: Install caps (Table 9) to cover all openings. If
plastic caps are not available, cover with tape.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Figure 84
2. Remove two M8 x 30 bolts securing the shielded
death, do not let engine fluids stay on your skin.
Clean skin and nails, using a hand cleaner, and
wash with soap and water.
clothing and rags contaminated with engine
fluids.
Figure 85 Tube fitting for EBP sensor
EGES295-2
Follow all warnings, cautions, and notes.
© 2006 International Truck and Engine Corporation
Exhaust tube bolts (upper right)
tube exhaust assembly. Discard exhaust tube
gasket.
WARNING: To prevent personal injury or
77
Wash or discard