Replacing The Rear Light Completely (Led Lighting Unit) - Invacare Spectra XTR Service Manual

SERVICE MANUAL

7.11.3 Replacing the rear light completely (LED lighting unit)

Note
Replacing an individual LED is not possible. If there is a defect, replace the entire rear light.
Requirements:
 Phillips screwdriver
 TX40 torx screwdriver
 oblique pliers
 cable binder
The position of the plugs is described in Chapter4.2.

Remove legrests.

Release seat (1) and tilt forwards.

Disconnect the remote bus cable from the
electronics module or ACT.

Lift the seat out of the front anchorage
and remove it. When doing so, get the
help of a second person because the
seat is heavy.

Remove both battery cases as described
in Chapter 7.7.1.

Remove the drive wheel as described in
Chapter 7.15.

Remove the rear light plug from the
lighting PCB.

Free the cable or remove any cable ties.

Undo the Phillips screw (1) with a Phillips
screwdriver and remove it together with
the washer.

Remove the rear light (1) from the splash
guard and replace it.

Reassembly takes place in the reverse
order.

To complete, check all vehicle functions.
66
®
Invacare - Bora