®
Invacare
- Bora
7.19
Replacing the lifter
Requirements:
small blade screwdriver
13 mm jaw spanner
24 mm jaw spanner
24 mm ring spanner
Allen key 5 mm
oblique pliers
cable binder
Run the lifter up to the top position if
possible.
Tilt the seat tilting completely to the rear if
possible.
Remove legrests.
Release seat (1) and tilt forwards.
Disconnect the remote bus cable from the
electronics module or ACT.
Lift the seat out of the front anchorage and
remove it. When doing so, get the help of a
second person because the seat is heavy.
Remove both battery cases as described in
Chapter 7.7.1.
Remove the actuator motor plug on the
actuator module.
Open the lifter energy chain. To this, lift
the cover (1) up on each chain link and
pull the clip (2) out.
Pull the cable out of the chain and
expose completely.
SERVICE MANUAL
83