Replacing The Electronics - Invacare Spectra XTR Service Manual

SERVICE MANUAL
7.3

Replacing the electronics

The various electronics modules can be fitted to the mobility device with a range different remotes.
The possible electronics modules are described in Chapter 4.2.
Replacement is described below using the Shark electronics module as an example. The course of
action is the same for other electronics modules. The only difference is the terminal layout.
WARNING!
Any changes to the drive program can affect the driving characteristics and the tipping
stability of the mobility device!
 Changes to the drive program may only be carried out by trained Invacare® specialist
dealers!
 Invacare® can only give a warranty for safe mobility device driving behaviour - especially the
tipping stability - for unaltered standard drive programs!
Note
All electronics modules are delivered with a standard drive program. If you have carried out
customer-specific modifications to the drive program, you will have to make these changes again
after installing the new electronics module.
Requirements:
 Phillips screwdriver
 To adapt the drive program:
programming software or hand programming device and system installation manual, available
from Invacare®.

Remove legrests.

Release seat (1) and tilt forwards.

Disconnect the remote bus cable from
the electronics module or ACT.

Lift the seat out of the front anchorage
and remove it. When doing so, get the
help of a second person because the
seat is heavy.
42
®
Invacare - Bora