Replacing The Rear Light Completely (Led Lighting Unit) - Invacare Bora Service Manual

®
Invacare - Bora/Spectra XTR

7.11.3 Replacing the rear light completely (LED lighting unit)

Note
Replacing an individual LED is not possible. If there is a defect, replace the entire rear light.
Requirements:
· Phillips screwdriver
· TX40 torx screwdriver
· oblique pliers
· cable binder
The position of the plugs is described in Chapter 4.2.
· Remove legrests.
· Release seat (1) and tilt forwards.
· Disconnect the remote bus cable from the
electronics module or ACT.
· Lift the seat out of the front anchorage and
remove it. The seat has a heavy weight. Use
proper lifting techniques.
· Remove both battery cases as described in
Chapter 7.7.1.
· Remove the drive wheel as described in
Chapter 7.15.
· Remove the rear light plug from the lighting
PCB.
· Free the cable or remove any cable ties.
· Undo the Phillips screw (1) with a Phillips
screwdriver and remove it together with the
washer.
· Remove the rear light (1) from the splash
guard and replace it.
· Reassembly takes place in the reverse order.
· To complete, check all vehicle functions.
SERVICE MANUAL
77