SERVICE MANUAL
7.4
Replacing the G-Trac sensor
Requirements:
5 mm Allen key
10 mm socket wrench
Switch the electronics OFF.
Remove the legrests.
Release the seat (1) and tilt forward.
Disconnect the remote bus cable from the
electronics module or ACT.
Lift the seat up out of its forward mounting
and remove completely. Try to get a second
person to help you with this, as the seat is
quite heavy.
Remove the battery boxes, as described in
chapter 7.7.1.
Disconnect the cable of the G-Trac sensor
from the electronics module.
Loosen and remove the nuts (3).
Remove the G-Trac sensor holder (1)
together with the G-Trac sensor (2).
Loosen and remove the self-locking nut (4)
and Allen screw (3), including the washers.
Remove the G-Trac sensor (2) from the G-
Trac sensor holder (1).
Replace the G-Trac sensor.
44
®
Invacare
- Bora