®
Invacare
- Bora
7.11.2 Replacing the front bulb holder (LED lighting unit)
Requirements:
Jaw spanner 7 mm
Allen key 3 mm
TX25 torx screwdriver
oblique pliers
cable binder
Loosen the nut (2) with a 7 mm jaw
spanner and a 3 mm Allen key and
remove.
Remove the front headlight (1) from the
lamp holder (3) and place it carefully to
the side.
Undo and remove the two screws (4) with
a TX25 torx screwdriver.
Replace the lamp holder (3).
Reassembly takes place in the reverse
order.
To complete, check all vehicle functions.
SERVICE MANUAL
65