Replacing Complete Rear Light (Led) - Invacare Storm4 Series Service Manual

Removing Headlight Holder
1. Remove rear and centre shroud. See 6.6.1 Replacing
Rear Shroud, page 21 and 6.6.2 Replacing Centre Shroud,
page 22.
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
5. Loosen screw (1) and remove headlight from holder.
6. Loosen both nuts (2) and remove holder from rubber
mounting.
7. Replace holder.
Installing Headlight Holder
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.

6.11.4 Replacing Complete Rear Light (LED)

For the LED lighting unit the rear light shroud is the equivalent of a holder. To replace the rear light shroud, see
6.6.4 Replacing Rear Light Shroud, page 22.
• 4 mm Allen key
• 13 mm socket wrench
• Oblique pliers
• Tie wraps
Removing Rear Light
1. Remove rear and centre shroud. See 6.6.1 Replacing
Rear Shroud, page 21 and 6.6.2 Replacing Centre Shroud,
page 22.
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
1555830-C
Fig. 6-48
Fig. 6-49
Fig. 6-50
Service
51