Table of Contents
Advertisement
•
4 mm wrench
•
Philips screwdriver
1. For position of the plugs see corresponding controls manual or earlier revision of this manual.
2. Remove legrests.
3. Adjust seat angle so that there is enough space to work. See Setup.
4. Disconnect remote bus cable from power module or ACT.
5. Remove headlight plug from lighting PCB.
6. Free cable or remove any tie-wraps.
7.
Loosen screws C.
8. Remove headlight (A) and lamp holder (B).
9. Install parts in reverse order.
10. Test all functions.
6.10.2 Replacing rear light (LED light)
Replacing an individual LED is not possible. If there is a defect, replace entire rear light.
•
Phillips screwdriver
•
13 mm wrench
1. For plug position, see corresponding controls manual or earlier revision of this manual.
2. Remove legrests.
3. Disconnect remote bus cable from power module or ACT.
4.
Remove rear light plug from lighting PCB.
5. Free cable or remove any tie-wraps.
6. Loosen and remove Phillips screw C.
7. Loosen and remove screws B.
8. Remove rear light A from splash guard and replace it.
9. Install parts in reverse order.
10. Test all functions.
6.11 Replacing posture belt
•
10 mm socket wrench
•
4 mm Allen key
1608312-B
Service
33
Advertisement
Table of Contents
