Shark Ii Remote Error Codes And Diagnostic Codes - Invacare Spectra XTR Service Manual

®
Invacare - Bora
6.4

Shark II remote Error codes and diagnostic codes

The drive electronics can automatically rectify some faults. In this case the status display will stop
blinking. Switch the remote on and off again several times. Wait around 5 seconds each time
before switching the remote on again. If this does not rectify the fault, determine the cause using
the following link codes:
Blink
Code
1
2
3
4
5
6
7
8
9
10
11
MEANING
Operating error Set drive lever to neutral central
position (just release drive lever) and
switch on again
Battery error Check battery and mains cable
Charge batteries.
If you switch the mobility device off for a
few minutes, the batteries can often
charge themselves up enough to
enable a short journey. You should,
however, only use this solution in
emergency situations because it results
in excessive battery discharging.
Replace batteries
Fault on left-hand Check motor cable and connecting
motor (M2) plug.
Check motor.
Fault on right-hand Check motor cable and connecting
motor (M1) plug.
Check motor.
Fault at left-hand Check cable and plug.
(M2) motor brake
Fault right-hand Check cable and plug.
(M1) motor brake
Error in Shark Check bus cable in remote and
remote connecting plug.
Replace remote.
Error in Shark Check all the cables and plugs in the
power module Shark system.
Replace electronics module
Communication Check all cables and connecting plugs
error in Shark in the Shark system.
system
Replace remote.
Unknown error Check all cables and connecting plugs.
Incompatible The wrong remote has been connected.
remote Ensure that electronic module code and
the remote code match.
SOLUTION
SERVICE MANUAL
Documentation
See chapter 7.9.
See operating manual
See chapter 7.7.
See chapters 7.7 and
7.2
See chapters 7.7 and
7.2
See chapter 7.7.
See chapter 7.7.
See chapter 7.7.
See chapters 7.7 and
7.3
See chapters 7.7 and
7.3
See chapter 7.7.
See chapter 7.3.
33