Show Termination Point Data - LightSand S-2500B Installation And User Manual

Show Termination Point Data

This command is used for viewing data about a termination point. The TP type must be entered
with the TP number. Currently POS (Packet Over SONET) is the only type of termination
point supported.
The following shows the level-specific prompt, the "?" request and the list of valid commands:
gateway/show/tp#
Sub-Context: pos
Cur-Context: (none)
Example: Select the POS 1 termination point and view the available commands:
gateway/show/tp# pos 1
gateway/show/tp/pos/1# ?
Sub-Context: (none)
Cur-Context:
Example: Display the distance, in milliseconds, between two gateways on the WAN.
gateway/show/tp/pos/1# info
A-28
?
info
all-info
S-2500B Gateway