LightSand S-2500B Installation And User Manual page 49

Close the system doors.
5.
Replace the front bezel.
6.
Reconnect the system and any attached peripherals to their electrical outlets, and turn them
7.
on.
Log into the CLI program as the user named admin and enter the correct date and time.
8.
(Refer to "Configure the System" on page
To test the newly installed battery, power down and disconnect the system from its
9.
electrical source for at least 5 minutes.
After 5 minutes connect the system to its electrical source and turn the power on.
10.
Log into the CLI and verify that the date and time are still correct. If not, call LightSand
11.
Product Support at (408) 941-2010, option 2.
1 System battery
Figure 4-9: Replacing the System Battery
A-9.)
Troubleshooting 4-11