Replacing Components; Access To The System Interior - LightSand S-2500B Installation And User Manual

Replacing Components

The procedures in this section require that you open the cover and work inside the system. Do
not attempt to service the system except as instructed in this manual or in other LightSand
documentation.
CAUTION: Be certain to use proper ESD protection, including a wrist grounding
strap, when performing the procedures in this section.

Access to the System Interior

A lock on the front bezel restricts access to the interior of the system.
Use the system key to unlock the keylock on the bezel, press the tab at each end of the
1.
bezel, and then pull the bezel away from the system (see
If the system is installed in a rack, loosen the front-panel thumbscrews that secure the
2.
system to the rack cabinet, and slide the system out of the rack to the slide assembly's fully
extended position.
Remove the security screw that is installed on the system cover (see
3.
Two doors on the top of the system provide access to the internal components.
.
4-2
Figure 4-1: Removing the Front Bezel
S-2500B Gateway
Figure 4-1).
Figure 4-2)
1 Keylock
2 Front bezel
3 Tabs (2)