Table of Contents
Advertisement
McData:
A McData switch should be configured for open_fabric.
The following two steps are optional:
Step 6: Configure SNMP agent
You may set some basic SNMP information using the following optional commands:
gateway:> config sys name <name>
gateway:> config sys location <location>
gateway:> config sys description <description>
You should use descriptive values for <name>, <location>, and <description>. As soon as the
gateway name has been set, the CLI prompt will change from "gateway:>" to the gateway
name. For example:
gateway:> config sys name Area2
Area2:>
Next, tell the system where to send traps:
gateway:> config snmp trap add X.X.X.X PPPP
where X.X.X.X is the IP address and PPPP is the port number of the SNMP monitoring
system (i.e. the trap receiver). Repeat this command to add multiple trap receivers. If the trap
receiver is not on the same subnet as the LAN management interface, then you need to specify
the default router (see Step 1).
Step 7: Verify the configuration
The following optional commands can be used to show information about the gateway and
verify the setup:
gateway:> show sys all-info
gateway:> show sys all-port
gateway:> show sys all-tp
gateway:> show port sonet 1 info
gateway:> show tp pos 1 info
vi
S-2500B Gateway
Advertisement
Table of Contents
