Table of Contents
Advertisement
Configuration Commands
The CLI supports configuration of LightSand gateways (also called nodes or systems), and
their cards, ports and termination points. (For adding nodes to the network, the GUI must be
used instead of the CLI.)
The following shows the level-specific prompt, the "?" request and the list of valid commands:
gateway/config# ?
Sub-Context: system lgrp ip card port tp usr snmp
Cur-Context:
Example: Reset the password of the logged-in user to "foobar".
gateway/config# passwd
New password: foobar
Retype new password: foobar
For discussions of the sub-context commands, see the following:
•
Configure the System (page A-9)
•
Configure LGRP Data (page A-10)
•
Configure System Level IP Channel Data (page A-17)
•
Configure a Card (page A-13)
•
Configure a Port (page A-14)
•
Configure a Termination Point (page A-15)
•
Configure SNMP Data (page A-10)
A-8
mac
passwd
S-2500B Gateway
Advertisement
Table of Contents
