Configure A Termination Point - LightSand S-2500B Installation And User Manual

Configure a Termination Point

These commands can be used to create, delete or update a termination point. A logical channel
runs from a termination point (TP) on one gateway to a TP on another gateway in the network.
The only type of TP currently supported is Packet Over SONET (POS). The S-2500B Gateway
supports only one POS TP on the SONET port. The following shows the level-specific prompt,
the "?" request and the list of valid commands:
gateway/config/tp#
Sub-Context: pos
Cur-Context: (none)
To access the commands available for a POS TP, the TP number must be specified:
Example: View the commands available for POS 1:
gateway/config/tp# pos 1
gateway/config/tp/pos/1# ?
Sub-Context: ip
Cur-Context:
create <time-slot> <payload-type>
delete
name <tp-name>
description <tp-descr>
admin-status <admin-status>
credit-grant-threshold <credit-grant-threshold>
credit-grant-period <credit-grant-period>
init-round-trip-delay
Decide if the wide area link will carry FC traffic, IP traffic, or both, then use ONE of the
following options:
FC traffic only
gateway:> config tp pos 1 create ch-c fc
IP traffic only
gateway:> config tp pos 1 create ch-c ip
?
CLI Reference A-15