Table of Contents
Advertisement
Configure SNMP Trap Data
These commands can be used to designate or undesignate the Manager's IP address, to which
SNMP traps should be sent. The port number should be specified as 162.
The following shows the level-specific prompt, the "?" request and the list of valid commands:
gateway/config/snmp/trap#
Sub-Context: (none)
Cur-Context:
Example: Designate a particular gateway in the network, by IP address and port number, to
receive traps from this system:
gateway/config/snmp/trap#
?
add <host-ipaddr> <host-port>
delete <host-ipaddr>
add 192.168.1.42 162
CLI Reference
A-11
Advertisement
Table of Contents
