Table of Contents
Advertisement
CLI Overview
The LightSand Command Line Interface allows the user to communicate directly with an
individual S-2500B Gateway (also referred to as a system or node).
CLI Access Privileges
The CLI provides two accounts which have different access privileges. The default user names
of those accounts are admin and user.
The admin account (default password is password) has full privileges for all types of
commands on the gateway: viewing system information, changing the user's own password,
configuring system components, adding and deleting users, installing software revisions,
activating the network manager, and setting the system date and time.
The user account (default password is password) is limited to the following activities:
viewing system information and changing the user's own password.
Login
To establish a CLI session over a serial link between the gateway and a console, connect a null-
modem DB-9 serial cable (supplied with the system) from the serial port on the back panel of
the S-2500B to the serial port of the console. The following settings should be used: baud rate
9600, no parity, 8 bits, 1 stop bit.
Alternatively, a CLI session can be established using a Telnet connection to the gateway from a
computer on the LAN. The gateway must have an IP address before it can be reached over the
LAN. Refer to the section on
When a CLI session has been established the following lines will appear (for example):
SWAN OS v1.0.0
login:
Appendix A: CLI Reference
Assigning an IP Address, on page
CLI Reference
3-2.
A-1
Advertisement
Table of Contents
