LightSand S-2500B Installation And User Manual page 47

Installing a Replacement SCSI Hard Drive
If your replacement hard drive is installed in its carrier, go to step 4.
1.
If the replacement hard drive has no carrier, remove the faulty hard drive from its carrier:
2.
Remove the four screws that secure the drive to the carrier (see
3.
Remove the hard drive from the carrier.
4.
Figure 4-8: Removing the SCSI Hard Drive From the Carrier
Insert the replacement hard drive into the carrier and install four screws to secure the drive.
1.
Open the handle on the carrier and install the replacement hard drive and carrier into its slot
2.
in the drive bay (see Figure 12).
Close the handle until it engages the front panel, locking the drive in place.
3.
Replace the front bezel.
4.
Turn on the drive bay and reintegrate the drive.
5.
1
2
3
Troubleshooting
Figure 4-8).
Hard-drive carrier
Screws (4)
Hard drive
4-9