LightSand S-2500B Installation And User Manual page 7

gateway:> show tp pos 1 ip info
gateway:> show tp pos 1 ip rip info
gateway:> show port fc 1 info
gateway:> show port ether 1 info
gateway:> show port ether 1 ip info
gateway:> show port ether 1 ip rip info
gateway:> show port ether 1 info
gateway:> show ip all-routes
gateway:> show snmp trap info
If all configuration parameters look good, the system is ready to operate.
Use the following command to reboot the system while keeping the current configuration:
gateway:> reboot
Use the following command to reboot the system and restore it to the factory default settings:
gateway:> config sys restart cold
Use the following command to shut the system down without rebooting:
gateway:> shutdown
Quick Start Guide
(if IP enabled)
(if IP enabled)
(if FC enabled)
(if IP enabled)
(if IP enabled)
(if IP enabled)
(if IP enabled)
vii