Table of Contents
Advertisement
Configure LGRP Data
(This section is under development.)
Configure SNMP Data
These commands can be used to add or delete entries in the SNMP (Simple Network
Management Protocol) configuration file. These entries designate which OPX system will
receive traps from this system, and set the SNMP community strings.
The following shows the level-specific prompt, the "?" request and the list of valid commands:
gateway/config/snmp#
Sub-Context: trap community
Cur-Context: (none)
For discussions of the sub-context commands, see the following:
•
Configure SNMP Trap Data (page A-11)
•
Configure SNMP Community Strings (page A-12)
A-10
?
S-2500B Gateway
Advertisement
Table of Contents
