Table of Contents
Advertisement
Configure the System
These commands are used for configuring data about the system (gateway) that is in
communication with the current CLI session.
The following shows the level-specific prompt, the "?" request and the list of valid commands:
gateway/config/system#
Sub-Context: (none)
Cur-Context:
Example: Change the system name:
gateway/config/system# name <NewGatewayName>
Changes remain in effect until the gateway is given a restart-mode of "cold," which restores
the factory-set default configuration.
When restart-mode "warm-inactive" is issued, the activate command must be used to enable
the changes.
Example: Deactivate the system, change a port type and reactivate:
gateway/config# system restart-mode warm-inact
(Note that the system will reboot at this point, and the user must log in again.)
gateway/config# port efc 1 type fc
gateway/config# system activate
?
activate
name <name>
description <description>
ipaddr <ip-address> <net-mask>
location <location>
contact <contact>
date&time
restart-mode <restart-mode-option>
enable-rip <if-option>
disable-rip <if-option>
CLI Reference
A-9
Advertisement
Table of Contents
