Memory List And Characteristics; Table 3-2 Approved Memory List - Kontron AT8060 User Manual

throttle the memory interface in case of overheating. Memory can perform double refresh rate to get higher
maximum operating temperature.
Kontron recommends the use of validated memory with this product. Thermal issues or other problems may
arise if you don't use recommended modules. At the time of publication of this user guide, the following
memories memory list has been have been qualified and approved. As the memory market is volatile, this list
is subject to change, please consult your local technical support for an up to date list.
3.3.1

Memory List and Characteristics

Table 3-2:Approved Memory List
Manufacturer Part Number
M392B5273CH0-CK0
M392B1K70CM0-CK0
M392B5273CH0-YH904
VL33B5263E-K9S
M392B2G70BM0-YK0
SGU04G72H1BC2SA-BBRT
MT18JDF1G72PDZ-1G6
Memory should have the following characteristics:
• DDR3 1333 or DDR3 1600
• 1.35V or 1,5V
• Single or dual-rank modules are supported
• x4 or x8 memory with up to 4 ranks per DIMM
• Registered & ECC
• Only very low profiles (VLP) 0.72inches maximum heights (18.3mm)
Because static electricity can cause damage to electronic devices, take the following
precautions:
Keep the board in its anti-static package, until you are ready to install memory.
Wear a grounding wrist strap before removing the board from its package; this will
discharge any static electricity that may have built up in your body.
Handle the board by the faceplate or its edges.
Description
4GB VLP 1600 MHz RDIMM
8GB VLP 1600 MHz RDIMM
8GB VLP 1333 MHz LV-RDIMM
4GB VLP 1333 MHz UDIMM
16GB VLP 1600 MHz RDIMM
4GB VLP 1333 MHz UDIMM
8GB VLP 1600 MHz RDIMM
WARNING
22
Company
Samsung
Samsung
Samsung
Virtium
Samsung
Swissbit
Micron
AT8060
www.kontron.com