Table of Contents
Advertisement
Feature
Option
None, Hardware
Flow Control
RTS/CTS
VT-UTF8 Combo Key
Disabled, Enabled
Support
Recorder Mode
Disabled, Enabled
Resolution 100x31
Disabled, Enabled
Legacy OS Redirection
80x24, 80x25
Resolution
VT100, LINUX,
Putty KeyPad
XTERMR6, SCO,
ESCN, VT400
Force System Vga to Text
Disabled, Enabled
Mode
Install Legacy OS through
Disabled, Enabled
Remote
Redirection After BIOS
Always Enable,
POST
BootLoader
Description
89
Software Setup
Help text
Flow control can prevent
data loss from buffer
overflow. When sending
data, if the receiving
buffers are full, a 'stop'
signal can be sent to
stop the data flow. Once
the buffers are empty, a
'start' signal can be sent
to re-start the flow.
Hardware flow control
uses two wires to send
start/stop signals.
Enable VT-UTF8
Combination Key
Support for ANSI/VT100
terminals
On this mode enabled
only text will be send.
This is to capture
Terminal data.
Enables or disables
extended terminal
resolution
On Legacy OS, the
Number of Rows and
Columns supported
redirection
Select FunctionKey and
KeyPad on Putty.
Enable to Install Linux in
text mode When System
has Vga.
Enable to Install Legacy
OS like Linux in text/
graphics mode through
redirection When System
has Vga. This might not
work for all Linux
Versions.
The Settings specify if
BootLoader is selected
than Legacy console
redirection is disabled
before booting to Legacy
OS. Default value is
Always Enable which
means Legaacy console
Redirection is enabled
for Legacy OS.
AT8060
www.kontron.com
Advertisement
Table of Contents
