Table of Contents
Advertisement
2.8
Serial Interfaces
The AT8060 uses serial interfaces to manage the CPU, the only way to get visual information from the board
when used without a RTM806X. Serial ports are provided on the faceplate and on the RTM faceplate for
asynchronous serial communications. They are 16C550 high-speed UART compatible and support 16-byte
FIFO buffers for transfer rates from 9,6Kbps to 115,2Kbps.
Table 2-2:Serial Interface connector Pinout
Pin
Signal
1
RTS
2
DTR
3
TX#
4
GND
5
GND
6
RX#
7
DSR
8
CTS
Note:
Standard product uses a RJ-45 8 pins connector. RI (ring indicator) and DCD (data carrier detect)
signals are not available.
The pinout is a custom one, not the same as RS-232D TIA/EIA-561.
Signal Path:
COM1 is routed to a RJ45 on the frontplate or to the IPMC for SOL.
COM2 is routed to the RTM serial interface.
BIOS Settings:
Advanced -> Serial Port Console Redirection -> Console Redirection Settings (COM0 and COM1)
2.9
AMC Mezzanine
The AMC slot supports AMC.1 (PCIe) and AMC.3 (SAS/SATA) in addition to the AMC.0 base specification. The
AMC is hot swappable according to PICMG 3.0 Rev. 2.0 and supports mid-size AMC units.
One AMC site is available. Characteristics of the AMC are as follow:
•Type B+
•Supports mid-size single width mechanical format
•PCI-Express X8 (GEN2 2.5GTs or 5.0GTs) with reference clock on AMC FCLKA
•Fully compliant PCI-Express hot plug support
14
AT8060
www.kontron.com
Advertisement
Table of Contents
