CHECKING THE BULBS AND BULB SOCKETS
1
Dg Lg B
Ch Y
Br
1
Ch Y Br
Dg Lg B
CHECKING THE LEDs
The following procedures applies to all of the
LEDs.
1. Check:
• LED (for proper operation)
Improper operation → Replace.
M
MMM
M MMM
M
M MMM
M
a. Disconnect the speedometer assembly cou-
pler (speedometer assembly side).
b. Connect two jumper leads 1 from the bat-
tery terminals to the respective coupler ter-
minal as shown.
WARNING
_
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
c. When the jumper leads are connected to
the terminals the respective LED should illu-
minate.
Does not light → Replace the speedometer
assembly.
L
LLL
L LLL
L
L LLL
L
7 - 15
–
+
ELEC
M MMM
M
M MMM
M
M MMM
M
MMM
L LLL
L
L LLL
L
L LLL
L
LLL