Starting Circuit Cut-Off System Operation - Yamaha XV1700P Service Manual

ELECTRIC STARTING SYSTEM
EAS00756
STARTING CIRCUIT CUT-OFF SYSTEM
OPERATION
If the engine stop switch is set to "
main switch is set to "ON" (both switches are
closed), the starter motor can only operate if at
least one of the following conditions is met:
• The transmission is in neutral (the neutral
switch is closed).
• The clutch lever is pulled to the handlebar
(the clutch switch is closed) and the side-
stand is up (the sidestand switch is closed).
The starting circuit cut-off relay prevents the
starter motor from operating when neither of
these conditions has been met. In this
instance, the starting circuit cut-off relay is
open so current cannot reach the starter
motor. When at least one of the above condi-
tions has been met the starting circuit cut-off
relay is closed and the engine can be started
by pressing the starter switch.
WHEN THE TRANSMISSION IS IN NEUTRAL
WHEN THE SIDESTAND IS UP AND THE
CLUTCH LEVER IS PULLED TO THE HAN-
DLEBAR
1 Battery
2 Main fuse
3 Main switch
4 Ignition fuse
5 Engine stop switch
6 Starting circuit cut-off relay (relay unit)
7 Diode (relay unit)
8 Clutch switch
9 Diode (relay unit)
0 Sidestand switch
A Neutral switch
B Start switch
C ECU
D Starter relay
E Starter motor
F Decompression solenoid fuse
G Decompression solenoid coil
H Decompression solenoid thermistor
7 - 23
– +
ELEC
" and the