Yamaha XV1700P Service Manual page 48

2. DIAG mode inspection and adjustment (multi-function meter)
Mode Selection (Make sure to disconnect the coupler from the fuel pump.)
DIAG mode
1. While keeping both the SELECT and
RESET buttons pressed, turn "ON" the
main switch. Keep the buttons pressed for
8 seconds or more.
* All the segments are "OFF" except the
clock and the trip LCD.
* "DIAG" appears on the clock LCD.
2. Simultaneously press the SELECT and
RESET buttons for 2 seconds or more to
select an item.
(The engine cannot be started in this mode.)
Diagnosis mode
Enables the verification of the operation of the
actuator and various sensors.
* Turn the engine stop switch to "OFF".
(Turn it "ON" when the diagnostic code is
09 or 03.)
1. Press the SELECT and RESET buttons to
select the Diagnosis mode.
* RESET button = decrement
* SELECT button = increment
* A diagnostic code number appears on the
clock LCD.
2. Checking the operation of the actuator
* Turn "ON" the engine stop switch to start
the operation.
3. Checking the operation of various sensors
* The condition of the operation appears on
the TRIP LCD.
1 Clock
2 Odometer/tripmeter/fuel reserve tripmeter
4
1 - 31
FEATURES
Normal mode
Turn "ON" the main switch.
* The self-diagnostic function starts a sys-
tem check.
System normal
Normal meter display
1
2
3
3 RESET button
4 SELECT button
GEN
INFO
Malfunction detection
A fault code number
appears on the clock
LCD.
The engine trouble
warning light illumi-
nates.