Yamaha XV1700P Service Manual page 216

FRONT AND REAR BRAKES
1. Install:
• brake master cylinder
• brake master cylinder holder 1
NOTE:
_
• Install the brake master cylinder holder with
the "UP" mark facing up.
• Align the end of the brake master cylinder
holder with the punch mark a on the handle-
bar.
• First, tighten the upper bolt, then the lower
bolt.
2. Install:
• copper washers
• brake hose
• union bolt
WARNING
_
Proper brake hose routing is essential to
insure safe motorcycle operation. Refer to
"CABLE ROUTING" in chapter 2.
NOTE:
_
• While holding the brake hose, tighten the
union bolt as shown.
• Turn the handlebar to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables,
leads). Correct if necessary.
3. Fill:
• brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
4 - 39
CHAS
10 Nm (1.0 m • kg, 7.2 ft • lb)
New
32 Nm (3.2 m • kg, 23 ft • lb)
Recommended brake fluid
DOT 4