Yamaha XV1700P Service Manual page 380

Table of Contents

Advertisement

CRANKSHAFT AND CONNECTING RODS
d. Assemble the connecting rod halves.
NOTE:
_
• Do not move the connecting rod or crank-
shaft until the clearance measurement has
been completed.
• Lubricate the bolts threads and nut seats
with molybdenum disulfide grease.
• Make sure the projection c on the connect-
ing rod faces towards the left side of the
crankshaft.
• Make sure the characters d on both the con-
necting rod and connecting rod cap are
aligned.
e. Tighten the connecting rod bolts.
WARNING
• Replace the connecting rod bolts with
new ones.
• Clean the connecting rod bolts.
NOTE:
The tightening procedure of the connecting rod
bolts is angle controlled, therefore tighten the
bolts using the following procedure.
f. Tighten the connecting rod bolts to the
specified torque.
Connecting rod bolt
1st
15 Nm (1.5 m • kg, 11 ft • lb)
g. Tighten the connecting rod bolts further to
reach the specified angle 90° ~ 120°.
Connecting rod bolts
Final
Specified angle 90° ~ 120°
WARNING
When the bolts are tightened more than the
specified angle, do not loosen the bolt and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
5 - 112
ENG

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xv1700pc

Table of Contents