Trouble Shooting - iCanTek iCanView 240 User Manual

iCanView240/250 User's Guide
-
+
Relay
You can use the supported relay output to directly drive a maximum load of
30V AC/DC at 1A. By connecting additionally relay circuitry (such as optional relay
switch), it can also drive heavier loads.

6.2. Trouble Shooting

1. After iCanView240/250 is successfully installed.
• iCanView240/250 in viewing mode, neither channel name nor video is display and eventually timeout
message is shown up.
Check the power and network connection of iCanView240/250.
To check if the network is properly operating, open the browser and try to connect to any server.
Example) http://www.yahoo.com
Or open the MS-DOS Prompt and type the following.
ping www.yahoo.com
Then press Enter. If you see the "
To check if the iCanView240/250 is connected, open the MS-DOS Prompt and type the following.
ping [the IP of the server]
Example) ping 192.168.1.112
Relay Switch Power Supply
1V~30VDC/AC,1A
Relay1
Relay1
Fig. 6-5 Connection of Relay to iCanView240/250
Reply from ..." message it means that the network is working properly.
Alarm
Out
Device
Power
Supply(30V
~)
Optional
Relay Switch
Alarm
Out
Device
Power
Supply
VDC/AC,1A
Rev.1.0 (Dec.2006)
(1~30
)
53