Symbology Settings Table - CipherLab 9400CE Reference Manual

9400CE Mobile Computer
Read Redundancy
Level 0 = None
Level 1 = One time
Level 2 = Two times
Level 3 = Three times
Time-out
1~255 (second)

SYMBOLOGY SETTINGS TABLE

CCD/LASER
Codabar
Select Start/Stop
Characters
Transmit Start/Stop
Characters
Code 128 / EAN-128
Transmit Code ID (for
EAN-128)
Industrial 25 (= Discrete 25)
Start/Stop Selection
Verify Checksum
88
Reference Manual
No redundancy means one successful decoding will make the reading valid
and induce the "READER Event".
The higher the reading security is (that is, the more redundancy the user
selects), the slower the reading speed gets.
If "Three Times" is selected, it will take a total of four consecutive
successful decodings of the same barcode to make the reading valid.
It applies to the following scan modes only:
Aiming mode
Laser mode
Auto Off mode
Auto Power Off mode
DESCRIPTION
If "Transmit Start/Stop Characters" is desired, select one
set:
abcd / abcd
abcd / tn*e
ABCD / ABCD
ABCD / TN*E
Decide whether to include the start/stop characters in the
data being transmitted.
Decide whether to include Code ID ("]C1") will be
included in the data being transmitted.
This decides the readability of all 2 of 5 symbology variants.
For example, flight tickets actually use an Industrial 2 of 5
barcode but with Interleaved 2 of 5 start/stop pattern. In
order to read this barcode, the start/stop pattern selection
parameter of Industrial 2 of 5 should set to "Interleaved
25".
Decide whether to verify the checksum. If the checksum is
incorrect, the barcode will not be accepted.
None
3 sec.
DEFAULT
Enable
abcd / abcd
No
Enable
No
Enable
Industrial 25
No