Symbology Settings - CipherLab 9200 Reference Manual

7.2.8. SYMBOLOGY SETTINGS

On the Symbologies tab, determine whether to enable or disable a specific symbology.
Note: The symbology settings vary by the scan engine (CCD, 1D laser or 2D imager)
installed.
Open Reader Configuration as described in
1.
Tap Symbologies tabbed page.
2.
Refer to Appendix I -
installed scan engine.
Refer to the Symbology Settings Table in Appendix II -
Refer to the Symbology Settings Table in Appendix III -
Refer to the Symbology Settings Table in Appendix IV -
Scan Engine Settings
Chapter 7 Using Reader Configuration Utility
Launch Reader
for the symbologies supported by the
CCD (SM1).
Laser
2D Imager
Configuration.
(SE955).
(SE4500DL).
145