Symbology Settings Table - CipherLab CP30 Series Reference Manual

Timeout between same When in Continuous mode, set the minimum time that
symbols must stop detect before the scan engine decodes a second
same barcode. This reduces the risk of accidentally
scanning the same barcode twice.
 0.0~9.9 (second)

SYMBOLOGY SETTINGS TABLE

Laser Engine Description
Code 11
Check digit verification Decide whether to verify the check digit. If the check digit
is incorrect, the barcode will not be accepted.
 Disable
 One Check Digit
 Two Check Digits
Transmit Check Digit Decide whether to include the check digit in the data being
transmitted.

"Check digit verification" must be enabled.
 One or two fixed lengths
Select Length
 Range (1~55)
Codabar
CLSI editing When applied, the CLSI editing strips the start/stop
characters and inserts a space after the first, fifth, and
tenth characters of a 14-character Codabar barcode.
 The 14-character barcode length does not include
start/stop characters.
NOTIS editing Decide whether to include the start/stop characters in the
data being transmitted.
 NOTIS Editing is to strip the start/stop characters, i.e.
to disable "Transmit Start/Stop Characters".
 One or two fixed lengths
Select Length
(min/max)
 Range (1~55)
Code 128
GS1-128 Read GS1-128 barcodes with leading FNC1 character.
(UCC/EAN-128)
ISBT 128 Read ISBT 128 barcodes.
Industrial 25 (Discrete 25)
Select Length  One or two fixed lengths
(min/max)
 Range (1~55)
Appendix II Laser (SE955)
1.0 sec.
Default
Enable
Disable
No
4~55
Enable
No
No
4~55
Enable
Enable
Enable
Enable
4~55
151