Initial Clear; All Clear; Initial Clear Key & Print Sheet; All Clear Key Sequence & Print Sheet - Sam4s ER-5200 Service Manual

3 Installation and Operation
3-3 Operation

3-3-3 Initial Clear

1. Turn off the power switch.
2. Turn the mode key marked 'P' to P-MODE.
3. Hold down the 'SBTL' key on the keyboard and turn on the power switch at the same time.

3-3-4 All Clear

This step insures that the cash register is cleared of any totals or programming. After this procedure, the cash register is
ready for programming and operation.
WARNING: This is a one time procedure. Do not repeat this procedure after the cash register is
programmed, it causes all programs and totals to be erased and to be default.
1. Turn off the power switch.
2. Turn the Mode key marked 'S' to Service Mode position.
3. Press and hold the CHECK key on key board and turn on the power switch at the same time.
4. When the buzzer beeps, press 'RECEIPT FEED', 'PLU9', 'CLERK', and 'CASH' in sequence.
5. When memory is cleared, the register prints a message "RAM ALL CLEAR OK!"
Note] Other Models (ER-5215, ER-5240) are same.
3-6
Figure3-9 Initial Clear Key & Print Sheet(ER5200)
Figure3-10 All Clear Key Sequence & Print Sheet
DATE 01/31/2003 FRI
= = = = = = = = = = = = = = = = = = = = = = =
INITIAL CLEAR OK!
= = = = = = = = = = = = = = = = = = = = = = =
CLERK 00 No.000036
DATE 01/31/2003 FRI
= = = = = = = = = = = = = = = = = = = = = = =
ER-5215 EPROM INFO.
VERSION
CHECKSUM : 887C
JANUARY 31 2003
= = = = = = = = = = = = = = = = = = = = = = =
CLERK 00
TIME 16:10
0000
TIME 16:01
RAM ALL CLEAR OK !
: 1.0 USA
No.000001
SAM4S ER-5200 Series
00000