Product Specifications; General Specifications - Sam4s ER-5200 Service Manual

2 Product Specifications

Specifications are correct at the time of printing. Product specifications are subject to change without notice.
See below for product specifications.

2-1 General Specifications

Item
Processor
Memory
Battery
Data Storage
Interface Serial
(RS-232C)
Interface Serial
(IRC)
Printer
Auto Cutter
Display
Key Board
Power Consumption
Power Requirement
Environment
Condition
Weight
Dimensions(mm)
SAM4S ER-5200 Series
• MITSUBISHI M16C/80 Group M30800SFP (16 Bit)
• RAM
SRAM (KM681000) : 1MBITs or 2MBITs
SRAM (KM684000) : 4MBITs × 2EA(Option)
• ROM
Flash ROM : 8MBITs (AM29F800)
• Type
: Ni-MH, 3.6V 60mAh
• Charging Time
: 24 Hours
• Life
: 3 Years
• 60 Days
• Flow Control :
① DTR / DSR : H/W Flow Control
② XON / XOFF : S/W Flow Control
• Baud Rate
: 1200 / 2400 / 4800 / 9600 / 19200 Bps
• Connector
: DB9P Female (I/F PBA)
• Voltage Supply
: VCC(+5V/200mA) supplies at 9Pin of Connector.
• Flow Control :
① XON/XOFF : S/W Flow Control
• Baud Rate
: 9600 Bps
• Connector
: Modular Jack Connector 12Pin (2 Port-6Pin)
• Model
: Shin Heung STM-210
• Printing Speed
: 50 mm / Sec (13.3 Line / Sec)
• Type
: Guillotine
• Cutting Method
: 1 Point Partial Cutting
• Operator Display
: VFD (10 Digits) or 2 Line Character LCD
• Customer Display
: VFD (10 Digits)
• Flat Rubber Key
: 160 Key (ER-5200 / ER-5200M)
• Raised Key
: 60 key / 90 Key
(ER-5215 / ER-5240 / ER-5215M / ER-5240M)
• Approx. 25W (Regularity)
• AC 120V 60Hz, 230V 50Hz
• Temperature
: 0℃ ~ 45℃
• humidity
: 30% ~ 80% RH
• 15.2 Kg (SET), 17.6Kg(Box Packing)
• 400(W) × 455(L) × 305(H)
Table2-1 General Specifications
Description Remark
External ROM Version
When battery is Full
charged
RS-232C #1
RS-232C #2
Same as RS-485 2-Wire
Communication Method
Detail Spec refer to Next
Page
2-1